Attleboro, MA
Bellingham, MA
Canton, MA
Framingham, MA
Franklin, MA
Franklin, MA
Mansfield, MA
Milford, MA
Natick, MA
North Attleboro, MA
Uxbridge, MA
Walpole, MA
Woonsocket, RI
Ashland, MA
Ashland, MA
Blackstone, MA
Cumberland, RI
Dover, MA
Foxborough, MA
Holliston, MA
Hopkinton, MA
Medfield, MA
Medway, MA
Mendon, MA
Westwood, MA
Sharon, MA
Attleboro, MA
Bellingham, MA
Canton, MA
Framingham, MA
Franklin, MA
Franklin, MA
Mansfield, MA
Milford, MA
Natick, MA
North Attleboro, MA
Uxbridge, MA
Walpole, MA
Woonsocket, RI
Ashland, MA
Ashland, MA
Blackstone, MA
Cumberland, RI
Dover, MA
Foxborough, MA
Holliston, MA
Hopkinton, MA
Medfield, MA
Medway, MA
Mendon, MA
Westwood, MA
Sharon, MA
Boston does not make garage door repair easy. Triple-deckers with a single bay cut into the ground floor, condo buildings with shared basement parking, narrow driveways in Dorchester and West Roxbury where the door is the only thing between the car and the street. A broken spring or a dead opener in this city is rarely a simple swap. It usually means working around tight clearances, low headroom, or a door that was installed decades before anyone thought about building codes for garages.
AB Garage Door is based in Bellingham and covers towns south and west of Boston, including the city itself. We work on torsion springs, extension springs, cable drums, rollers, and the openers that sit above them, and we explain what broke and why before we touch anything. If your door is stuck half open right now, call 508-794-7439.
Most calls we get from Boston fall into two camps. The first is a spring that has let go, usually with a bang loud enough that a neighbor comes to check. The second is an opener that has stopped responding, which is almost never the opener itself but a door that has gone out of balance and is asking the motor to do work it was never built for. Both of these get worse if you keep using the door, so the sooner you stop and call, the less damage there is to repair.
We carry spring sets, cable, rollers, and common opener parts on the truck, because a second trip to a Boston address with parking restrictions and resident-only streets costs everyone time.
We handle repair, new installation, and ongoing service for both residential and commercial garage doors. Since Boston sits outside our regular town-by-town service area, we don’t run separate pages for every repair type here, but the work itself is the same work we do across Bellingham and the surrounding towns.
Boston has plenty of commercial overhead doors tied to businesses that can’t afford to stay closed for a day: loading docks, auto shops, warehouses, parking structures. These doors see far more open-close cycles than a residential door and the springs, cables, and openers wear accordingly. We service and repair commercial sectional and rolling doors, and we work with building managers who need a door back in service with minimal disruption to the tenants or business behind it.
Torsion springs are mounted on a shaft above the door and wound under heavy tension, which is why we never advise a homeowner to replace one themselves. The repair involves unwinding the old spring safely with winding bars, fitting the correct size and wire gauge for your door’s weight, and rebalancing the whole system afterward. Extension springs, the kind that stretch along the horizontal tracks, fail differently and usually take a cable or pulley with them when they go. Either way, if your door won’t stay up, feels heavy to lift by hand, or made a loud noise before stopping, that’s a spring problem, not an opener problem.
When a door is past repairing, or a Boston property is being renovated and needs a new door sized to fit an altered opening, we handle full installation. That includes sizing for tight or nonstandard openings common in older Boston construction, fitting new track and hardware rated for the door’s weight, and setting up an opener correctly from the start so it isn’t fighting an unbalanced door on day one.
Outside of outright breakdowns, a yearly check on spring tension, track alignment, and hardware wear catches small problems before they turn into a stuck door at 7am on a weekday. This matters more in the city, where a door blocking a single-car driveway or a shared alley isn’t just inconvenient, it can hold up a whole morning.
A door that won’t close is a security problem as much as an inconvenience, and a door that won’t open with the car trapped inside stops your day cold. We prioritize these calls. Tell us on the phone what the door is doing – won’t move at all, moving but off-track, opener running but door not responding – and we’ll tell you roughly what’s wrong and what to expect before we arrive.
A lot of Boston’s housing stock predates the attached two-car garage entirely. In Dorchester, Roslindale, and parts of Jamaica Plain you see single-bay garages tucked under triple-deckers, often with a door sized closer to 8 feet wide than the 16-foot double you’d find in a newer suburb. Headroom in these setups can be tight, which matters when we’re fitting a torsion spring system that needs clearance above the door to wind safely.
Newer construction in parts of Hyde Park and along the outer neighborhoods tends toward standard single or double garages attached to the house, similar to what you’d find in any post-war Massachusetts suburb. Condo developments and multi-family buildings with shared garage structures are their own category, often with heavier commercial-grade doors and openers rated for more frequent cycling than a typical residential unit.
Salt air isn’t a Boston-specific issue the way it is on the South Shore, but winter road salt and the freeze-thaw cycle still take a toll on tracks and hardware, especially on doors facing a plowed street.
Boston traffic and parking restrictions are a real factor in how a repair goes, not just a line we add for flavor. Resident permit streets, narrow alleys behind triple-deckers, and loading zones with time limits all affect how quickly a truck can get set up at your address. We plan around this rather than treating it as a surprise.
Garage door repair pricing depends on what actually failed. A torsion spring replacement costs more than a roller replacement, and a full opener swap costs more than a sensor realignment. Panel damage pricing depends on whether the panel is still made for your door model or needs to be sourced. We give you a price before we start work, not after, so you’re not signing off on a number you haven’t seen. Call 508-794-7439 and describe what the door is doing, and we’ll talk you through what the repair is likely to involve.
Yes. We're based in Bellingham and regularly service Boston addresses, including neighborhoods with tight driveways and shared parking structures.
In most cases yes. Low headroom setups sometimes need a different spring configuration or a low-headroom track kit, which we can assess on site before any work starts.
This is usually a disconnected or worn drive mechanism, a stripped gear inside the opener, or a door that's come off its track. It is rarely the remote or the wall button, so don't waste time replacing batteries.
No. A broken spring means the opener or your own strength is doing the lifting alone, which strains the opener and can bend the door's tracks. Leave it where it is and call us.
We’re licensed and insured in Massachusetts and New Hampshire, and we run service calls into Boston from our base in Bellingham on a regular basis. If you’re dealing with a stuck door, a snapped spring, or an opener that’s quit, call 508-794-7439 and we’ll get a crew moving.
Not every job is an emergency. If you’re pricing out a new door, planning a replacement, or want someone to look at a door that’s just getting noisy or sluggish, reach out for a free quote. We’ll ask a few questions about the door and the property and give you a straight answer on cost and timing.